Logitech UE MegaBoom Outer Mesh Replacement

Written By: Oscar Ambriz

Comments: 8

Logitech UE MegaBoom Outer Mesh Replacement

Difficulty

Easy

Steps

Time Required

5 minutes

Introduction

This is a guide designed to assist you in removing and replacing the Logitech UE Megaboom outer mesh.

Tools

Step 1

Locate the ends of the speaker.
Put a plastic opening tool in-between the rubber end and the mesh.
Apply a upward force in order to pry open the end.
Apply this procedure to the other side as well.
Will take force.
Using metal tools may permanently mar your device.

Pry all the way around with the tool as there are “clips” that hold the cap in place all around beneath the cap. Avoid trying to “pull the lid open” from the opening of a half opened lid.

Jamin Hu - 01/01/21

Stop! Before you proceed, notice the comments at the end of the guide. You don't have to take apart both sides or remove the mesh fabric. Remove just the bottom cap (with the aux/charge plug).

Then carefully remove the glue securing the circuit board on the sides and gently pull the board out to reveal the battery under it.

Caleb Kelsay -

FWIW I had no luck opening these caps with the tools I bought on iFixit (plastic pry bar, metal Jimmy). I had a lot more luck using the flat edge of a butter knife! (it still took lots of work on my UE Megaboom 3)

Travis Taylor -

My megaboom berttrey doesn't charge it becomes like power defending

Lawrence Memsong -

Step 2

Take the Jimmy and pry up the rubber strip that has the volume buttons on it.
You will hear clicks as it pries up, don't worry.
Remove all the rubber you pried off.

Step 3

Use tweezers to lift end of plastic retainer on edge of mesh out of its channel.
Work the plastic retainer out of the channel all the way around the speaker.
Be gentle, it is easy to damage the fabric.
Repeat for other side.