LifePrint 2x3 Battery Replacement

Written By: Alex Ephraim
  • Comments: 6
LifePrint 2x3 Battery Replacement

Difficulty

Easy

Steps

4

Time Required

10 - 20 minutes

Introduction

Is your LifePrint 2x3 not holding a charge? The issue at hand may be that the battery is faulty and not working. If your device is failing to hold a charge, the battery may need to be replaced. Consider using this guide to replace the faulty battery in your device.

  1. M3mwe3YMawpEEfkN
    M3mwe3YMawpEEfkN
    xBkWgiAneqBKBYBq

    • Orient the LifePrint 2x3 so that the top of the device is facing upwards. Slide the top cover toward the far side of the device and remove it.

  2. CDMK6AKxZ61N21HA
    CDMK6AKxZ61N21HA
    GWO6ieNjOQL33KkH
    jgYXwNcS33LoNqaS

    • Remove the six 5.24 mm screws located around the edges of the device using a Phillips #00 Screwdriver.

  3. w3rvuQNQTWZibOVj
    w3rvuQNQTWZibOVj
    2D5cgtF2A2IO5OMQ
    fAega6kCmHFcdAhP

    • Flip the LifePrint 2x3 upside down. Using a plastic opening pick, separate the bottom cover from the device and remove it.

  4. MtKSlBbOYt3fgQAD
    MtKSlBbOYt3fgQAD
    Y6yIl6JW46pTxt4D
    pikXk6lZcFdId2rC

    • Using the angled tweezers grip the sides of the connector and slowly rock it side to side to remove. If the connector is not disconnecting, try using the spudger but be careful not to damage the motherboard.

    • Once disconnected, remove the old battery.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Alex Ephraim

Member since: 24/09/19

160 Reputation

6 comments

Hi. Where can you buy the replacement battery? Thank you.

martin.thomas -

Where can whe buy that battery?

lp1979 -

Hi can I know where I can buy the battery?

Amelia Halliwell -

bel article but where to buy the battery ?

What kind and characteristics of the battery ?

Baphi -

I found it hard to buy the battery, you can buy 2 small Li ion batteries of 3.7V, and put them in series, that way you get a battery you can use
Is something homemade but it works. Reutilize the 5P with the NTC, and connect the NTC to ground if your 3V doesn't have one.

Btw original characteristics are
- 7.4V nominal
- 8.4V charge
- 500mAh
- 3.7Wh
https://es.aliexpress.com/item/100500537...

Burquillo Polamillo -

@burquillop63692 That battery link you posted seems to meet those battery characteristics you posted and it has a 5 pin connector on it already. Do I just order that battery and its plug and play or is there some modifications that need to be done?

Ryan Johnson -