Introduction

You will be removing the back panel, disconecting the

battery and upgrading/replacing the RAM.

  1. bnbsSJVifDBO12qC
    bnbsSJVifDBO12qC
    FHoUgCLNMlsxTYII
    • Unscrew and take out 10, 1/5 cm screws.

    • Unscrew and take out 1, 1 inch screw.

    • I use a piece of tape sticky side up to place screws on, also I label it where they go.

  2. JJa6NwpEm3bJla6f
    JJa6NwpEm3bJla6f
    kU246cMTTYcELyNH
    sF1KK5GsrkkOQKwE
    • With the vents facing away from your body I find it easiest to start at the bottom right corner first and gently pry up the corner using a plastic tool.

    • Then slide and pry the plastic tool to the left corner.

    • Then work on the sides.

  3. N5F1nPHry1CmOZJo
    N5F1nPHry1CmOZJo
    OBaEuSsUA1BDRXaI
    S15jOLsuywIvtIYf
    • Carefully lift up on the back panel.

    • The back will snap out of place but be careful and don't force it to hard.

  4. AcmDo5bZNcLJZDA3
    AcmDo5bZNcLJZDA3
    UmZ5NweogRGHCjuK
    • Pull the battery cable out of it's connector. Gripping the wires in the middle gently wiggling the wires back and forth while pulling.

    • With the battery connector out.

  5. mAwrlyCCkcd4IbDO
    mAwrlyCCkcd4IbDO
    nIjAdesrAhghHFPs
    XG3DidWORo5PQWsu
    • Note the tabs on each side of the RAM holder,

    • With your fingers or the plastic tool gently move the tabs away from the RAM, the RAM should pop up when both sides or moved.

    • Grip the RAM by the sides and lift out.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Corbin Schon

Member since: 26/01/16

593 Reputation

One comment

Thank you for the guide! It helped me to feel sure about the disassemble.

cacalo219 -