Kurio 7 Back Panel Replacement

Written By: Eric Rice
  • Comments: 0
Kurio 7 Back Panel Replacement

Difficulty

Moderate

Steps

4

Time Required

7 minutes

Introduction

If the back panel of your Kurio 7 is broken, this is an easy process to replace it. This also serves as a guide to opening the device for other repairs and replacements.

  1. XS2tmgOcOoOxITQg
    XS2tmgOcOoOxITQg
    DhX4W2c2FhQLcRvt
    iGYg5H61UlMjnYFZ

    • Begin by removing the rubber cover from the Kurio 7.

  2. gH31wiOTJnvOsALs
    gH31wiOTJnvOsALs
    ublYBRaX1ATXYNvs

    • Remove the four 30 mm Phillips #00 screws from the outer case.

  3. HOvyilJQnqtZfIUL
    HOvyilJQnqtZfIUL
    TwPIg446ObgR4FBt

    • Insert the plastic opening tool in the gap between the front cover and the back cover of the device.

    • Slide the plastic opening tool around the edge of the device. Gently pry apart the tabs that hold the front cover and the back cover together.

    • Be careful not to break off the tabs that hold the front cover and the back cover together.

  4. GYrrDo5bqoFHFaXB
    GYrrDo5bqoFHFaXB
    Qwaf4JItbbADTgSl

    • Once all of the tabs are removed, the back cover should come off easily.

    • Gently remove the back cover. There are wires inside that may get caught on the cover while removing it. These wires are soldered to their components and are difficult to reattach.

Conclusion

Replace with a new back panel. To reassemble your device, follow these instructions in reverse order.

Author

Eric Rice

Member since: 14/04/14

913 Reputation

0 comments