Introduction

  1. WlRHKhaD2KIRks2E
    WlRHKhaD2KIRks2E
    axTQufCGHgimNlCq
    • Use a TX10 screwdriver

    • Remove the housing screws on the rear of the device.

    • 6 long screws

    • 3 short screws

  2. xcEuGxp1OLUOYoQp
    • Place the device with the white lid facing up.

    • Start to carefully lift the lid at the front of the suction nozzle. Slowly work your way up to the stem.

    • At the top of the stem, a small plastic part holds in the gray casing of the suction cup!

  3. LPdhxHy6VALwCduo
    • Now you can lift the flap of the vacuum cleaner bag. This was only held by the white lid.

  4. dUEQEZEtEIQGhlfx
    dUEQEZEtEIQGhlfx
    hDJRbpP5b625AIHC
    • Disconnect the power supply connector by pressing the unlocking lever.

    • Unplug the motherboard connector.

    • Put the cable aside

  5. TPaoPGtXEbCGV3iA
    TPaoPGtXEbCGV3iA
    XlXFfbJDPSMISIe2
    I6MJlgYCbPEOqiHi
    • Unlock and loosen the rotary switch plug.

    • Disconnect the white air hose from the intake manifold.

    • Release 2 plastic clips

    • Remove the wiring harness with the plastic holder.

Conclusion

Follow the steps in reverse order to reassemble your device.

Lukas Fritz

Member since: 25/12/19

362 Reputation

0 comments