Introduction

This guide will show you how to open the body of the AngelSound to disconnect the motherboard from the case. You will need knowledge of how to use a soldering iron station. For more information regarding soldering visit: Soldering Skills

  1. swEJpbagWglJRXoD
    • Access the battery compartment

    • Remove the battery compartment lid and set it aside.

    • Disconnect the battery and set it aside.

  2. JtJKXkYEdS1fjfka
    JtJKXkYEdS1fjfka
    SUb5Ba1VPDPPtWCZ
    • Puncture the sticker in the battery compartment with a spudger to access the screw beneath it.

  3. 2FysPPajdBAAY1e2
    • Remove the 7mm Phillips #1 screw from the battery compartment.

    • Place the screw in a secure place.

  4. X4R14LC4pBFVCAHZ
    X4R14LC4pBFVCAHZ
    HOnV4eL1oiK5TNRy
    • Begin prying open the device.

    • Insert a plastic opening tool into the side groove about 2cm from the pink plastic component and pry open one side of the device.

    • Once the side is separated, leave the opening tool inside to prevent the two sides from closing.

  5. 3xHXXZVagHJZqDZw
    3xHXXZVagHJZqDZw
    qpOVrfPROUhWEIOQ
    • Insert another plastic opening tool into the groove opposite to the side of the tool already inserted.

    • Create separation on that side until the white plastic component comes off entirely.

    • Place the white plastic component in a secure place.

  6. pxQjIXTJlTjAdg2e
    • With your hand, remove the pink component.

  7. VLqniQMMJEqrqqKC
    • Remove the 7mm Phillips #1 screw in the middle of the motherboard.

Deron Rogers

Member since: 31/08/15

271 Reputation

0 comments