Insignia NS-B4111 Antenna Replacement

Written By: Kristin Yoshioka
  • Comments: 0
Insignia NS-B4111 Antenna Replacement

Difficulty

Moderate

Steps

6

Time Required

15 minutes

Introduction

This guide shows you how to remove the antenna from the boombox.

  1. MTvHc2TYYASCSJRS
    MTvHc2TYYASCSJRS
    2VVstQSXbviHp3XB

    • Unplug and remove the power cord. Turn the boombox upside down.

    • Grip the sides of the case and use your thumbs to pop open the battery cover.

  2. btEi6YwPnNTItM2s
    btEi6YwPnNTItM2s
    qN6l5HJmwoaoGPIT

    • Pry out the batteries with your fingers.

  3. CUGXqojkAxAXBTkx

    • Set the boombox upright. Remove the 4mm screw and the two 6mm washers with the Phillips PH1 screwdriver.

    • Remove the external antenna.

  4. vsBRZniguSDsOEyk

    • Turn the boombox upside down again. With the Phillips PH1 or the Flathead #3 screwdriver, remove the three 14mm black screws.

    • Remove the four 18mm chrome screws with the Phillips PH1 screwdriver.

  5. argNBHYZeZf6giaI
    argNBHYZeZf6giaI
    BLPtTop6AomjuNqO

    • Gently remove the bottom half of the casing from the top half of the casing.

    • The antenna base is connected to the motherboard by a red wire. This wire will prevent the two halves from separating completely.

  6. VK2jSRM1YSv3cC2F
    VK2jSRM1YSv3cC2F
    l1glB2t4AHKUAQoP

    • Remove the 10mm chrome screw from the antenna base with the Phillips PH1 screwdriver. Remove the antenna base from the casing.

    • This red wire will now be loose and you can move it out of the antenna base slot.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Kristin Yoshioka

Member since: 21/09/16

984 Reputation

0 comments