How to strip J-Y(ST)Y 2x2x0,8 Telecommunications Cables

Written By: Sebastian
  • Comments: 0
How to strip J-Y(ST)Y 2x2x0,8 Telecommunications Cables

Difficulty

Easy

Steps

6

Time Required

15 seconds - 1 minute

Introduction

J-Y(St)Y cables are a type of multi-conductor cable commonly used for low voltage signal transmission in various applications such as telecommunications, data processing, and industrial control systems.

The cable consists of multiple twisted pairs of insulated copper wires with an overall shield made of aluminum foil or copper braid. The shield provides protection against electromagnetic interference (EMI) and crosstalk between the individual pairs.

The number in the designation (e.g. "2x2x0,8") indicates the number of conductors and their cross-sectional area. For example, a J-Y(ST)Y 2x2x0,8 cable has two pairs of conductors, each with a cross-sectional area of 0.8 square millimeters.

J-Y(St)Y cables are often used in structured cabling systems for connecting various devices such as computers, switches, and routers to each other and to the central control system. They are designed for indoor use and can be installed in conduit, cable trays, or directly in walls or ceilings.

  1. ipBUhYkcw2GGqemY
    ipBUhYkcw2GGqemY
    CpRFSFJmgSQVQWps

    • Use wire cutters to make a clean cut on the end of the cable you want to strip.

  2. 4eW6KQxHTg5YSAn1
    4eW6KQxHTg5YSAn1
    YpPHFDJrQDLdBWI6

    • Grip the cable with a stripping tool for communication cables and twist it to cut the mantle.

    • Pull off the mantle.

    • It depends on what you want to do with the wire, but usually stripping off about 5cm is a pretty good starting point.

  3. YKt6RT1jUO4ToHFX
    YKt6RT1jUO4ToHFX
    pxVVHdIrlWwgobgi

  4. tqRvpCYWdUqLCiiY
    tqRvpCYWdUqLCiiY
    uoIHHAlCsCwLVrSb

  5. NHbdJblvrGZCFyYh
    NHbdJblvrGZCFyYh
    UbXThwVwlLPaGvLH

    • Pull back the grounding wire and wrap it around the cable.

  6. HQhAMAqmsXKFLNWk
    HQhAMAqmsXKFLNWk
    JD3LFq4BUyIJE2vJ
    L2jf5kW6LigegkKn

    • Stripping the wire itself is optional, depending on what you want to do with it. P. ex. if you are going to punch it down into an LSA Plus block, you don't need to strip the wire.

    • Grip the wire with the 0.8 mm notch and pull off the insulation or use automatic wire strippers.

    • Stripping off 1cm is usually enough.

Conclusion

Good luck on your next project!

Author

Sebastian

Member since: 19/08/18

25411 Reputation

0 comments