How to replace a QMR Rail-Hook on a bike bag. (new bike bag)

Written By: Daniel Schmid
  • Comments: 0
How to replace a QMR Rail-Hook on a bike bag. (new bike bag)

Difficulty

Moderate

Steps

4

Time Required

5 minutes

Introduction

A QMR Rail Hook on your hardback panel (attachment hook on the rack) is responsible for the correct positioning of the bike bag on your rack. It can be re-attached or replaced in a few easy steps.

  1. 6U6e1NxDgGEGtXVn

    • To remove the broken buckle, you will need a large flat head screwdriver.

  2. Disassemble: Unscrew the orange dial and remove the damaged QMR rail hook and wire spring.

    • Disassemble: Unscrew the orange dial and remove the damaged QMR rail hook and wire spring.

  3. Pry out the washer using two flat head screwdrivers.

    • Pry out the washer using two flat head screwdrivers.

  4. Push the new washer in and use the screwdriver to move it into place. Place the threaded oval plate and wire spring directly on top of each other. The hole of the threaded plate must be directly above the hole of the washer. Screw on the new QMR Rail Hook.

    • Push the new washer in and use the screwdriver to move it into place. Place the threaded oval plate and wire spring directly on top of each other. The hole of the threaded plate must be directly above the hole of the washer. Screw on the new QMR Rail Hook.

    • Please note: The QMR rail hook must click into place — then you’ll know it is correctly threaded.

Conclusion

Finished! You did it.

Author

Daniel Schmid

Member since: 22/02/16

387 Reputation

0 comments