How to Replace The Bottom Shower Door Seal

Written By: Omar Escobedo
  • Comments: 0
How to Replace The Bottom Shower Door Seal

Difficulty

Easy

Steps

7

Time Required

10 - 30 minutes

Introduction

This step-by-step guide shows how to replace the shower door seal found at the bottom of the shower door. Generally speaking, the shower door seal strip should be replaced every 1-2 years; however, also consider replacing it if it is torn, cracked, or too dirty.

  1. BPUGKWZHFpmMf1vd
    BPUGKWZHFpmMf1vd
    pOfqcDcWBfLPai4A

    • Remove the old shower door seal by sliding it off the door.

  2. hgHrCYCwPNx3IXLp
    hgHrCYCwPNx3IXLp
    yXCcAtfSu6kJFfCK

    • Clean the area where the old seal was at the bottom of the shower door.

  3. QRRcU22Nw4mhhns3

    • Measure the old shower door seal.

  4. wD3pRvyEMRnyIJJg

    • Mark how long the new shower door seal should be per the previous measurement.

  5. FbAom6NFBmMJMNEA

    • Cut the new shower door seal on the mark placed in the previous step.

    • Use whichever cutting tool is available that can cut this material.

  6. Kwh2pZC4BQKqTX2A

    • Sand/Smooth Off the side of the seal that was cut in previous step.

  7. F6CTi3GLoHPM16gK
    F6CTi3GLoHPM16gK
    WYjpTfwaIkVB4IuQ
    Z3d4XC1autHQCgE1

    • Slide the new seal on with the deflector facing the inside of the shower.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Omar Escobedo

Member since: 23/10/23

145 Reputation

0 comments