How to Remove the Motor on Your Whirlpool Dryer Belt Switch Test Prereq

Written By: Bill Gilbert
  • Comments: 0
How to Remove the Motor on Your Whirlpool Dryer Belt Switch Test Prereq

Difficulty

Moderate

Steps

7

Time Required

No estimate

Introduction

  1. NIrRYHJ3QXwg3xmN
    NIrRYHJ3QXwg3xmN
    mFOWfdtS6hPBYfWi
    XWHkN3uEpcKFIgyS

    • Use a flat head screwdriver or a spudger to lift the connector locking clips.

    • Disconnect the connector by pulling it straight off.

    • Be sure to grip the connector and not the wires when disconnecting.

  2. y5ngIXEiPXnE2L1E
    y5ngIXEiPXnE2L1E
    XiAKnKyQjTwVFurg
    bi3RdMKlJWiKfeTM

    • Use long nose pliers to disconnect the first belt switch wire.

    • Be sure to grip the connector and not the wire when disconnecting.

    • The third photo will help on reassembly.

  3. NsBKsWI126pZeu4w
    NsBKsWI126pZeu4w
    htKYSCE6KHYptc4Q

    • Disconnect the second belt switch wire.

  4. ZlWoWtBuLrHJsCjn
    ZlWoWtBuLrHJsCjn
    BjSOrPE5LCImsQRq

    • This step shows how to test the belt switch will require a multimeter. If you aren't familiar with how to use one, here is a guide that will help you.

    • Check the continuity between the switch wires while the idler pulley arm is down.

    • The multimeter should show an open circuit (OL).

    • Next, test to see that the belt switch shows continuity when the idler pulley arm is raised.

    • The multimeter should read less than 1 Ω.

    • If the switch fails either of these tests, replace it. Go on to the next step.

  5. 3fpuVKyvVVdLNdJS
    3fpuVKyvVVdLNdJS
    Ie6KFKDLYEZdStvC
    jUt6rouuqoksJMVx

    • Use one hand to press down on the motor retainer clip bump. This should make it easy to unhook the clip from the motor cradle mount.

    • While maintaining the downward pressure, use your other hand to unhook the clip from the motor cradle mount.

    • Your motor may be mounted differently, but the principle is the same.

  6. TfBiYGCiBnXYEonC

    • Lift the motor retainer clip off the motor and remove it.

    • Repeat the last two steps for the other motor clip.

  7. UBFM6kYLURTKHKqC
    UBFM6kYLURTKHKqC
    jboVgJMOBJHZ2SP3

    • Lift the motor out of the motor mount and remove it.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Bill Gilbert

Member since: 30/06/22

34697 Reputation

0 comments