How to Fix a Popped Rubik’s Cube

Written By: Giovanni Román

Comments: 0

Difficulty

Easy

Steps

Time Required

3 - 5 minutes

Introduction

This guide is a tutorial on how to reassemble your Rubik's cube if a piece has popped from the tensions. This may happen if the springs become loose. There is an explanation at the end of the guide on how to tighten your tensions so that it doesn't occur as often in the future. You only need a Phillips head screwdriver to adjust the tensions.

Tools

Step 1

Place your cube down and look for the popped pieces.
Collect all the popped pieces and group the corners and the edges separately.

Step 2

Place the pieces layer by layer to make it easier to put the cube back together.
If only pieces that popped are from the second and third layer, start with the edges of the second layer.

Step 3

Place the edges and corners that popped from the third layer.

Step 4

Twist the third layer 45°.
Place the corners of the third and last layer.

Step 5

Last but not least, place the final edge piece.
To make it easier to place, pull apart the two corner pieces slightly and insert the edge at an angle. Twist it a little bit until it goes in.

Step 6

This last step is for cubes with this feature, like many speed cubes.
Remove the cap to expose the screw attached to the core.
You can remove the cap with your nails or any prying tool like a spudger or opening tool.
Tighten the loose screws. (It can be anywhere from 180° to 360°)
Make sure to tighten the screw enough so that it won't pop easily. Tightening the cube will make it pop less, but may make corner cutting worse. (Corner cutting allows turning with misaligned layers on speed cubes)

Conclusion

This simple yet effective fix will help you prevent any future pops in your Rubik's cube. I hope this guide helped you a lot!

Author

Giovanni Román

Member since: 18/03/22

187 Reputation

How to Fix a Popped Rubik’s Cube

Introduction

Tools

0 comments