Holmes HEH8031 Thermostat Replacement

Written By: Richard S Woodruff
  • Comments: 0
Holmes HEH8031 Thermostat Replacement

Difficulty

Easy

Steps

10

Time Required

3 minutes

Introduction

This guide shows step by step instructions for replacement of the thermostat assembly in the Holmes HEH8031 heater.

  1. UogmYGKZhULMlbxT

    • Ensure the device is unplugged from the wall outlet.

  2. NexjIoAibPGYpRyw

    • Remove eight 12-mm Phillips #2 screws from the back cover.

  3. bnBEBVAydwKLjwuU
    bnBEBVAydwKLjwuU
    5Tdgh3To1tPipGOs

    • Turn heater over so the controls are facing up.

    • Lift the front housing away from the back of the fan and slowly fold the front housing back down to the floor.

    • Internal wires are connected to both halves of the housing. Be careful when separating the housing.

  4. s4Vwf6XfFrZJeJYp

    • Remove four 12mm Phillips #2 screws from the circuit board.

  5. WoqATFpOrK3ocPvx

    • Remove two Phillips #2 12mm screws from housing

  6. JcKnJja4MyQaNcQa

    • Remove zip tie from wire with pliers

  7. kLQrWIWCBrQyQvZ2

    • Separate fan assembly from heating coil

  8. HJOCJNRqLeZG1Pik

    • Remove 1 Phillips #2 screw

  9. QNByaXRYu2dHprHH

    • Remove thermostat from rear housing

  10. MaXcY4MnuNxwyQfx

    • remove solder from thermostat wire on circuit board

    • Soldering iron will be hot

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Richard S Woodruff

Member since: 12/10/16

142 Reputation

0 comments