Holmes HEH8031 Safety Weight Replacement

Written By: Deanna Jack
  • Comments: 0
Holmes HEH8031 Safety Weight Replacement

Difficulty

Moderate

Steps

6

Time Required

20 minutes

Introduction

This guide will demonstrate how to remove and replace the safety weight in the Holmes HEH8031 Heater.

  1. UogmYGKZhULMlbxT

    • Ensure the device is unplugged from the wall outlet.

  2. NexjIoAibPGYpRyw

    • Remove eight 12-mm Phillips #2 screws from the back cover.

  3. bnBEBVAydwKLjwuU
    bnBEBVAydwKLjwuU
    5Tdgh3To1tPipGOs

    • Turn heater over so the controls are facing up.

    • Lift the front housing away from the back of the fan and slowly fold the front housing back down to the floor.

    • Internal wires are connected to both halves of the housing. Be careful when separating the housing.

  4. s4Vwf6XfFrZJeJYp

    • Remove four 12mm Phillips #2 screws from the circuit board.

  5. wdqSjaMJn21bvXlT
    wdqSjaMJn21bvXlT
    dJnXwlYSLnbMUlRJ

    • Remove wires from safety weight, as shown.

    • Pull upward on the blue connectors.

    • If connectors are tough to remove, try wiggling while pulling upward.

  6. GiguJGEl1m5l6wNZ

    • Unscrew the Phillips #2 10 mm screw from the safety weight on the rear housing panel.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Deanna Jack

Member since: 12/10/16

333 Reputation

0 comments