Introduction

This guide will walk you through the easy process of repairing or replacing the heater control buttons.

  1. UogmYGKZhULMlbxT
    • Ensure the device is unplugged from the wall outlet.

  2. NexjIoAibPGYpRyw
    • Remove eight 12-mm Phillips #2 screws from the back cover.

  3. bnBEBVAydwKLjwuU
    bnBEBVAydwKLjwuU
    5Tdgh3To1tPipGOs
    • Turn heater over so the controls are facing up.

    • Lift the front housing away from the back of the fan and slowly fold the front housing back down to the floor.

    • Internal wires are connected to both halves of the housing. Be careful when separating the housing.

  4. s4Vwf6XfFrZJeJYp
    • Remove four 12mm Phillips #2 screws from the circuit board.

  5. OsnRrfCi2EXetLQW
    OsnRrfCi2EXetLQW
    gys5wyoHbMjRFySw
    ZYNkpSCjc3V2QiDU
    • Remove the two Phillips #2 12mm screws from the button retainer.

    • Lift the button retainer off.

    • Remove the interconnected buttons.

    • If the buttons are broken, replace them.

    • If the buttons are sticking, clean them in warm soapy water and allow to dry.

  6. CsS1kpVYfIRYAvM6
    CsS1kpVYfIRYAvM6
    CNDkVNAhwpKZpvQQ
    LhrBKJkegPsKTanT
    • Using light finger pressure, carefully push the black plastic tabs off the white plastic hooks.

    • Remove the black plastic bracket out through the front of the heater housing.

    • Remove the two Phillips #2 12mm screws and remove the clear window from the black plastic bracket.

    • If the buttons were sticking, clean the black plastic bracket in warm soapy water and allow to dry.

    • If the clear window was dirty, clean it in warm soapy water and allow to dry.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Chris Shaffer

Member since: 12/10/16

255 Reputation

0 comments