Harman Kardon Onyx Studio 2 Control Board Replacement

Written By: Alexandra Achtenberg

Comments: 17

Harman Kardon Onyx Studio 2 Control Board Replacement

Difficulty

Easy

Steps

Time Required

10 - 20 minutes

Introduction

If the buttons on your device aren't working, it may be time to replace your control board. Follow this guide to do so.

Tools

Step 1

Using a plastic opening tool, pry off the front grill by wedging it in the notch on the front of the device.

Where can I find a new front panel for my speaker

consomme69 - 21/01/19

If I take this off can I put it back on

Burger King - 20/02/19

Step 2

Remove the five 14.4 mm T10 Torx screws.

There are NO torxscrews. You have to pull out the rubber grille grips that are inside the screw holes FIRST, then use a regular sized Phillips head screwdriver to remove the cover. No Torxscrewdiver needed. I found this out after I had already purchased one from you guys.

phillip columbus - 15/01/21

Mi bocina no tiene los 5 tornillos a la vista,tiene las cavidades ciegas, como lo abro???

Eduardo Heine -

Yes there are no Torx screws… you have to remove the rubber grips them the Philip Screws..

Joe Lim -

Step 3

Gently pull the front apart from the back.

Step 4

Remove the four wires connecting the front and back panels.
Pinch the connector tab and pull gently upwards.
Repeat for the other three connectors.

Please can I get a replacement of my panel to the phone

Chinedu Ogunedo -

Step 5

Pull the silicone button band off of the outer edge of the speaker.

Step 6

Disconnect the two pressure connections from the circuit board.

Step 7

Gently remove the control board band by placing fingers in contact with it through the button openings.
Work from the outer edges in so as not to bend the band.

From where to buy Control panel

ali - 19/03/18

From where to buy this control panel

ali - 19/03/18

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Alexandra Achtenberg

Member since: 02/02/17

2051 Reputation

9 comments

Do you guys know where to get a control board, because my board is broken so i am looking for one

Zhou Yuqi - 15/05/17

Where to get control board onyx 2.

Mike Champagne - 05/07/17

My on/off button keeps blinking…..would somebody please email me cause I am a techno nitwit……..i’m gonna bring this piece of non chargeable crap outside and go Italian on it with the 12 gauge! SERENITY NOW!

Sincerely,

email ; jorcal3318@aol.com

Frank Vitolo - 17/09/17

power button continually blinks. Won’t turn on, can’t pair, no other action can be taken, just the blinking power button. what’s the solution? Please share….

rachael friesen - 13/01/19