Harman Kardon Invoke Microphone on/off Button Replacement

Written By: Angel A. Grageda
  • Comments: 0
Harman Kardon Invoke Microphone on/off Button Replacement

Difficulty

Easy

Steps

5

Time Required

10 minutes

Introduction

This repair guide will help you replace the on/off button for the microphone on your Harmon Kardon Invoke. By replacing the microphone on/off button, this may resolve Cortana not responding when spoken to and ensure that the microphone is enabled at the appropriate time. For this repair, make sure you have a steady hand to prevent harming the internal hardware. While replacing the base screws, be sure to not strip them, otherwise, any future repair will be difficult.

  1. feYFgGYGuQAUY6TO
    feYFgGYGuQAUY6TO
    eXyoXAKMVFI1AUwt

    • Use a metal spudger to remove the rubber bottom.

  2. iSdROsKEvLbryDxo
    iSdROsKEvLbryDxo
    ApK6fMfhDLeAUgGj

    • Use a Torx #10 screwdriver to remove the four 14.0 mm screws.

  3. FYCLaBRxoJSyu2OV
    FYCLaBRxoJSyu2OV
    J1mhmEfNnbgC6WiZ

    • Firmly grip the bottom and wiggle it upwards to remove the base.

  4. ULwAYYjDIZRBcOyC
    ULwAYYjDIZRBcOyC
    kmRTKcQc1dKNJsxD

    • Use a Torx #10 screwdriver to remove three 10.0 mm screws from the highlighted board attached to microphone button.

  5. Ifn16YJWbVgeM3rY
    Ifn16YJWbVgeM3rY
    DFdHn2yRcuH12mTe

    • Pull the cable lightly to disconnect the button board from device.

    • To replace the microphone button, you will have to replace the entire smaller board.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Angel A. Grageda

Member since: 02/10/18

686 Reputation

0 comments