HP eStation Zeen Ground Wire Replacement

Written By: dalton hale
  • Comments: 0
HP eStation Zeen Ground Wire Replacement

Difficulty

Difficult

Steps

5

Time Required

35 minutes

Introduction

If the troubleshooting procedures and all of the previous steps do not work it may be time to change the motherboard ground wire.

  1. TYGm3ToPuQXY2seR
    TYGm3ToPuQXY2seR
    JiFXICiWqRNoygJf
    bxgLUmltTxgdWrFo

    • Remove the screw caps using a metal spudger.

    • Remove the four 6 mm screws using a Phillips #0 screwdriver.

  2. JChTeSu4Fc6LTNUw
    JChTeSu4Fc6LTNUw
    jhpdBWuYDNoSyLbF
    AUNgbXhrcYPhAHSR

    • Insert a plastic opening tool into the case seam and slide it along the edges.

    • Lift and remove the back panel from the device.

  3. hh2BlKfFfJjN2vru

    • Carefully disconnect the battery clip using small plastic spudger.

    • The clip is extremely fragile.

  4. DUMuHjE4UnXCdoZQ

    • Use tweezers to disconnect the ground wire from motherboard terminal.

  5. 6nljEyauLTfMOqHf

    • Use a soldering iron to remove the ground wire.

    • Avoid touching or heating the motherboard.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

dalton hale

Member since: 26/09/16

503 Reputation

0 comments