GravityLight Dial Replacement

Written By: Michallynn Hoffman
  • Comments: 0
GravityLight Dial Replacement

Difficulty

Easy

Steps

5

Time Required

5 - 10 minutes

Introduction

If the dial is stuck, then you will need to take the GravityLight apart to replace the dial. Also, you should replace the dial if you can turn it and the brightness does not change.

  1. kbSEYgCjc6yTDfaw
    kbSEYgCjc6yTDfaw
    lnHEJoYi6CICoJXT

    • Flip the GravityLight on its back and place it on a sturdy surface.

    • Unscrew the three 2cm Phillips #00 screws on the back of the GravityLight’s body.

  2. cRbvBmMQ4fVLRaug

    • Some of the internal pieces may loosen or fall out during disassembly.

    • Firmly grasp both parts of the GravityLight body and pull them apart.

  3. hRGrtAuvCYoAXcr1

    • Take the thinner of the two parts, the front piece, and place it face down on a sturdy surface.

    • Ignore the back piece for now, but keep it in a safe place.

  4. BtMrhSpZdactDU52
    BtMrhSpZdactDU52
    CM1U2ABOAaCW5Ppf

    • Use two hands to push the dial tabs inward, towards the center of the dial.

    • Push the tabs downward and through to the other side of the casing.

    • Flip the front panel over.

  5. oB2UnS5XPRDmJRAi

    • Fully remove the dial by pulling it out from the front.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Michallynn Hoffman

Member since: 26/09/14

317 Reputation

0 comments