Fujifilm Endeavor 100ix Battery Door Replacement

Written By: Eric Nicolai
  • Comments: 0
Fujifilm Endeavor 100ix Battery Door Replacement

Difficulty

Moderate

Steps

7

Time Required

No estimate

Introduction

Use this guide to replace the battery door.

  1. GbQWjLT1MISY1EfJ

    • Locate and remove two 6.4mm screws on the bottom of the camera with a Phillips #00 screwdriver.

  2. APjDgL4WgTQxeqbD

    • Locate the battery door.

  3. N2jFlmLa2OOMFDov

    • Locate the latch on the battery door.

    • Use your finger pry to it open where it says "BATT."

  4. HJxUYfDWa6gdEyXb

    • Remove the battery from the camera by pulling the battery door outward.

  5. bLhRHWOZIDe5iexl

    • Locate and remove three black 3.80mm screws on the back of the black casing with the Phillips #00 screwdriver.

  6. HwI6CdR22S22rOZL

    • Squeeze the camera placing a thumb on the tab marked CE.

    • Pull the back half of the camera firmly away from the camera body.

  7. QJyIY4vZuXlIihvn
    QJyIY4vZuXlIihvn
    ZVKyr2ahbQewSCKq

    • Locate and remove the 3.80mm screw that holds the plastic strip to the camera body with a Phillips #00 screwdriver.

    • The plastic strip will now come off the camera body.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Eric Nicolai

Member since: 11/01/11

679 Reputation

0 comments