Eureka 1660SP External Start Switch Realignment

Written By: Evan Fodi
  • Comments: 0
Eureka 1660SP External Start Switch Realignment

Difficulty

Easy

Steps

4

Time Required

20 minutes

Introduction

  1. XyeaAOLjBR6Xunq5
    XyeaAOLjBR6Xunq5
    A3B4M5V5gPMmNadg

    • Before you start, make sure your vacuum is unplugged the power outlet.

    • Press and hold down the black button below the handle while pulling the pole out.

  2. uGWXmJURxZYGnDlH
    uGWXmJURxZYGnDlH
    GbLFYifUZrYx5r6M

    • Press the black separator switch to separate the top and bottom halves of the vacuum.

  3. hSGgqLPE2VEgkHEq
    hSGgqLPE2VEgkHEq
    pxAEaH3NZEOMmMrm
    PTf4oTZPha5NmEtT

    • Use a #2 Phillips head screwdriver to remove six 13.9mm screws from the side of the motor housing (top half) as shown.

    • Remove two 14.1mm screws from the front face of the housing. You are now all set to open the housing.

    • Keep a watchful eye on the two screws from the front face. These two have additional collars to their necks and will not fit in any of the other holes, yet no other screw will fit in their spots without the collar.

  4. L6mUctZsHn2Sa1QU
    L6mUctZsHn2Sa1QU
    xFTluN2Ije3hPtXU
    du5CTOZcj1Yj4WeE

    • If the external switch is slightly misaligned as shown, realign it with the internal switch.

    • Make sure the spring loaded button on the underside of the housing is intact when reassembling the motor housing. It is prone to eject when opening the motor housing.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Evan Fodi

Member since: 24/09/13

122 Reputation

0 comments