Escort Passport 9500IX Display Replacement

Written By: Jiahao Xu
  • Comments: 2
Escort Passport 9500IX Display Replacement

Difficulty

Moderate

Steps

6

Time Required

8 minutes

Introduction

Is your radar's display not powering on or just hangs on a black screen? If this is the case, then the display could be at fault. Follow this guide to replace the display on your radar.

  1. MlYNlfLwIqFInckN

    • Remove the three 1.2 mm Phillips #1 screws on the back of the device.

    Where can I purchase the BUTTONS ???

    Sergio -

    I tried to look for the buttons on Google and eBay but couldn't find them.

    Sergio -

  2. q3KytcKK2BDUo1Uy

    • Pry off the back panel of the radar using the nylon spudger.

  3. Ba2JOoGMwGODtefi
    Ba2JOoGMwGODtefi
    RC3XjSBpA4hQYrOd
    WvwGjRSIVIBWaCwO

    • Carefully pry the grey frame off the black plastic covering using the nylon spudger.

  4. dJnooAeSevcTSIpB
    dJnooAeSevcTSIpB
    ZyvbYWPlJQwJdwBX
    GIDHJy2J2fLyEWPB

    • Detach the orange flap from the motherboard using a nylon spudger.

    • Carefully remove the motherboard from the grey plastic frame.

  5. cuiZ5xHaFDUlBBto
    cuiZ5xHaFDUlBBto
    GFYw2EQGppcHqpfU

    • Detach the remaining two orange flaps from the circuit board that is attached onto the grey frame.

  6. LStiVpt2R5dtUIWs
    LStiVpt2R5dtUIWs
    nLaOfBxOu1E4ErVS

    • Detach the display from the grey frame.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Jiahao Xu

Member since: 25/10/18

177 Reputation

0 comments