Enabot EBO SE Motherboard Replacement

Written By: Kevin H.

Comments: 0

Difficulty

Moderate

Steps

Time Required

5 - 10 minutes

Introduction

The motherboard is essential to the Enabot EBO SE because without it, nothing will function properly. Damages to the motherboard can lead to drastic results in the product's function. In this guide, we will show you how to access and replace your motherboard as smoothly as possible.

Tools

Step 1

Gently turn the robot upside down.
Place the robot on a stable surface to prevent it from rolling or falling.

Step 2

Use a flathead 2.5 mm screwdriver to remove the 5.7 mm screw from the wheels.
A tool should have been provided in the box for this purpose.

Step 3

Pull the wheel assembly towards you so it comes straight off without resistance.
If there is resistance, make sure to apply gentle force when pulling as it can get damaged with too much force.

Step 4

Use a Torx screwdriver to remove the four 9 mm screws from the assembly.

Step 5

Use your fingernail to carefully press down and eject the Micro SD Card from the back of the Enabot.
Keep the Micro SD Card in a safe spot for later.

Step 6

Place the iFixit opening tool inside the Micro SD slot.
Very carefully apply pressure to the top of the slot and pry open the casing to separate the upper and lower housing.

Step 7

Using the iFixit opening tool or your fingernail, place it underneath the gray tab on the lower housing.
Lift the tab up and pull out the ribbon cable to disconnect it from the lower housing.

Step 8

There are two black and red wire connectors attached to the upper and lower housing.
Gently use your finger nails to lift up and disconnect both wires to fully separate the upper and lower housings.

Step 9

Use the iFixit opening tool to unlock the side gray tab and free the orange & black ribbon cable.

Step 10

Use the iFixit opening tool to unlock the middle gray tab and free the orange & black ribbon cable.

Step 11

Select one of the release tabs on the edge of the upper casing that holds the motherboard in place.
Place one finger in between the motherboard and the upper casing.
Pull the release tab back while lifting the motherboard with your other finger to "pop" the motherboard out of the casing.