Element GC-1020 Headphone Jack Replacement

Written By: Lashaun Noel
  • Comments: 0
Element GC-1020 Headphone Jack Replacement

Difficulty

Moderate

Steps

3

Time Required

20 minutes

Introduction

Use this guide to access the headphone jack and check soldered connections. If you are planning to follow this replacement guide, you should have identified the headphone jack as a source of a problem (or maybe you just want to see the guts of your Element GC-1020).

  1. BNHUEhkppHt1nTow

    • Unscrew the four screws (size: 3.175mm) on the left and right side of the Element Electronics GC-1020 device using the PH#0 screwdriver.

  2. UO2RFBnNFqVwXmhh

    • Carefully pull the back of the device (the silver portion) apart from the rest of the device.

    • If you pull back too forcefully the power button would move out of place.

  3. PS2OAj4iUcJYf1TX
    PS2OAj4iUcJYf1TX
    MFATbVqj5sKqiKby

    • Desolder the four points where it is soldered to the motherboard.

    • When completed pull the headphone jack off using tweezers and replace.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Lashaun Noel

Member since: 25/09/15

591 Reputation

0 comments