Dexter 500W Corded Jigsaw - 500JS2-65.5 Replacement Blade Holder

Written By: Céline Chemineau
  • Comments: 0
Dexter 500W Corded Jigsaw - 500JS2-65.5 Replacement Blade Holder

Difficulty

Easy

Steps

6

Time Required

2 minutes

Introduction

This guide will show you how to replace the blade holder.

  1. AChZVoukEMBBH1W3

    • Before you begin, remember to disconnect the mains plug.

  2. XgrpvncVumYTVJ4J
    XgrpvncVumYTVJ4J
    NLXPgIaUIqwIBpmZ
    jnIKdTdJsA1cSiMy

    • Start by unlocking the tray.

    • Then unscrew to open the machine.

  3. Remove the blade holder, then remove the slider located at the end of the holder.

    • Remove the blade holder, then remove the slider located at the end of the holder.

    • Remember to keep the slider at the end of the support.

  4. Before replacing the new blade holder, re-grease, then replace it.

    • Before replacing the new blade holder, re-grease, then replace it.

  5. 5Ohh1bbxjXS15kRn

    • Check that each piece is in its place before closing.

  6. KjSSPpWJYmi6JCLM
    KjSSPpWJYmi6JCLM
    gZKMwFT1tWQTBRn4

    • Replace the shell and then screw it back on.

    • Retighten the chainring nuts to finish.

Conclusion

Follow the guide through to reassemble or in reverse

Author

Céline Chemineau

Member since: 29/01/20

16638 Reputation

0 comments