DeWalt DW920 Lock Switch Replacement

Written By: Stephen Rada
  • Comments: 1
DeWalt DW920 Lock Switch Replacement

Difficulty

Moderate

Steps

5

Time Required

15 minutes

Introduction

  1. CUytIWFnRph3vlUk

    • Using an H-5.0 bit driver remove the four T-10 Torx screws.

  2. fIlFKGRnLa1nKGan

    • Use 2 H-5.0 bit drivers to take out the main bolt and head.

    • There will be blue locktite on the tread.

  3. sH4XRZpuSDmcWJyZ

    • Carefully remove the two halves of the handle.

  4. 1nHTUJQEHIHMHsTU

    • Locate the switch on the top of the drill right before the bending joint.

  5. vQEBSLuXpCSqBWiA
    vQEBSLuXpCSqBWiA
    Djicja4RsBDWUWQe

    • Firmly grasp the switch with two fingers and lift it straight up. The spring should remain attached to the switch during this process.

    • It should lift right out. If it is caught on anything do not force it out.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Stephen Rada

Member since: 11/03/16

433 Reputation

One comment

This guide was descriptive and easy to follow. Good job!

DankMemerino -