CyberPower UPS Battery Replacement

Written By: Jervon Stuart
  • Comments: 0
CyberPower UPS Battery Replacement

Difficulty

Easy

Steps

7

Time Required

10 - 30 minutes

Introduction

This guide will instruct you on replacing the battery on the Cyberpower Model# 1000PFCLCD UPS battery backup unit.

  1. AIcBZQsQRJ63JZqZ
    AIcBZQsQRJ63JZqZ
    VCHcNlMMxWNop3uA

    • Power down the unit by pressing the power button until the display goes black.

    • This is usually about 3 seconds.

    • Unplug the power cord from the wall outlet.

  2. vR6NhQj5h5xSIC1s
    vR6NhQj5h5xSIC1s
    1WJcl5XXailkXnXu
    JSmBaWweppxIaBTl

    • Remove the battery plate cover at the bottom of the UPS using a Phillips #1 screwdriver.

    • If the screwdriver is not magnetized, tap on the cover plate to completely remove the screw.

  3. KpjYuMvRScSfI4Fn
    KpjYuMvRScSfI4Fn
    QBphdVWk3Vo1M1mN

    • Slide the battery cover plate to the left.

    • Grasp the battery plate cover and lift it off the the UPS.

  4. PufXwYnXS5NYWmiO
    PufXwYnXS5NYWmiO
    BTAiNfD5CGJhLSch
    W4UonJFNunnGbsfZ

    • Pull out the battery to expose the terminal connectors.

    • Use needlenose pliers to disconnect both battery terminal connectors.

    • Do not pull the connectors by the wires, pull connectors by grabbing the connector itself.

    • With the battery terminal connectors disconnected, slide the battery all the way out.

  5. qt5mNAGJriveRKxh
    qt5mNAGJriveRKxh
    XkytGaIVhwFMDHQj
    yIDTWHtGaRsCScRp

    • The replacement battery should be a 12 volt, 9 amp-hour, sealed lead acid battery with f2 type connectors.

    • Install the new battery and reconnect the terminals.

  6. TKKY1JHmwVZNg2aW
    TKKY1JHmwVZNg2aW
    C232yVKZqtUxIjbV
    1wjGDmcf6KKCUoLq

    • Slide the battery cover plate to the left.

    • Insert the screw to secure the battery cover plate.

    • Tighten the screw with a Phillips #1 screwdriver.

  7. tofUgpqYEroyrSL2
    tofUgpqYEroyrSL2
    bNrFGVfm4Zch6EP1
    kNmSr6q2tfT35wU1

    • Plug system into the wall outlet.

    • Press the power button to turn on the unit.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Jervon Stuart

Member since: 08/10/20

193 Reputation

0 comments