CyberHome CH-DVD 300 Power Supply Replacement

Written By: Chris Menezes

Comments: 10

CyberHome CH-DVD 300 Power Supply Replacement

Difficulty

Easy

Steps

Time Required

10 minutes

Introduction

Replacing the power supply involves unplugging the white connection cord from the power supply board after the top panel is removed.

Tools

Step 1

Turn the DVD player off. Unplugging the DVD player while it is on may result in damage to the DVD player or an inserted CD.
Unplug the DVD player from the wall socket.
Locate the 15mm Phillips screws on the left side (1 screw), right side (1 screw), and back (4 screws) of the DVD Player. Use the appropriate Phillips head screwdriver to remove the six screws.

Step 2

Remove the top panel of the DVD Player by:
Sliding the top panel backwards.
Gently lifting the back of the top panel up.

Step 3

Orient the device to locate the power supply board on the far right corner. Use needle nose pliers to pull the white connector from the power supply board.
The power supply board is connected directly to the power cord. This is not the same thing as the mother board.

Where can i get the new board?

semyonaxelrod -

Where can I get a new power supply board?

semyonaxelrod -

Conclusion

To reassemble your device, follow these instructions in reverse order.

8 comments

Very powerful

kojootengcharles - 18/07/15

Mine had a bad 2200uf 10v capacitor… I replaced it and the player works fine.

Robert Brackett - 04/01/18

What and where is that located please?

Kealani Rowe -

So what capacitor have u replaced ?

semyonaxelrod -

I need another power supply board. Mine has 4 blown Capacitors and do not know if any resisters or diodes or small capacitors are bad because I have now testing tools to check them. Just what I see with eyes. Am a retired electronics professional (79) and know what I am doing. Please let me know if I can get a power supply board and the cost. Thank You .

Glennie Waters - 22/12/18

So I guess no response?

semyonaxelrod -