Craftsman Model 315.10721 Cord Replacement

Written By: Riley Hilliker
  • Comments: 0
Craftsman Model 315.10721 Cord Replacement

Difficulty

Easy

Steps

3

Time Required

10 minutes

Introduction

WARNING: Once the power cord has been identified as the item that needs replacement, make sure that the device is disconnected from any power supply.

  1. PyVQrENdtYCPrUu3

    • Remove the two 1" Phillips screws using a #1 Phillips screwdriver.

    • Remove the three 1/2" Phillips screws using a #1 Phillips screwdriver.

    • Once the five screws are removed, lift the handle cover from the saw.

    • Each screw has a corresponding nut on the opposite side of the power saw

  2. 4NTblUWwW2Hq6R1R

    • Remove the 1/2" Phillips screw that is securing the switch using a Phillips #1 screwdriver.

  3. eFaplsw6LHuXcjKn
    eFaplsw6LHuXcjKn
    vstclmIVMvnf4Ukm

    • Using a Phillips #00 screwdriver or a small diameter screwdriver, gently insert it into the leads. When the screwdriver is inserted into the lead, it will release the wire.

    • The leads are where the black and white wires from the power cord are plugged in.

    • Release both the black and white wires and gently pull them from the leads.

    • To install the new cord, insert the wires of the new cord in the same way that they were removed.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Riley Hilliker

Member since: 14/10/14

557 Reputation

0 comments