Coby Kyros MID9042 Camera Replacement

Written By: Samantha Rollings
  • Comments: 0
Coby Kyros MID9042 Camera Replacement

Difficulty

Easy

Steps

3

Time Required

15 - 30 minutes

Introduction

This guide is provided to those who may need assistance on replacing their camera for a "Coby Kyros MID9042" tablet. Replacing the camera on a Coby Kyros MID9042 can be challenging but before you begin, make sure you have the necessary tools, a replacement camera, and a clean, well-lit workspace. Here's a step-by-step guide to help you through the process. Remember to exercise caution throughout the process, and if you encounter any difficulties, consult the device's user manual or seek assistance.


  1. AwZitfLVUdN3WDZS
    AwZitfLVUdN3WDZS
    coYTyaileYkXJhfB
    WbsoUKhnWfg4U24I

    • Before removing anything from the tablet, make sure to power off the device.

    • After powering off device, remove the anti-slip pads from all 4 corners on the back of the device.

    • Once slip pads are removed, proceed to unscrewing the four 3.2 mm Phillips #0 screws from the back cover.

  2. DhGxeUoXWrfNEdZC
    DhGxeUoXWrfNEdZC
    rg2RKUMw236RURBr
    XECx1426PJAXVUVQ

    • When removing the back cover, be careful not to break the inner plastic tabs.

    • Use the blue plastic opening tool to wedge the back cover apart from the front.

    • Once the edges are wedged apart, use hands to lift up the back of the tablet.

  3. EKQcX442UrgWcigG
    EKQcX442UrgWcigG
    iKF1M5CRKWJaQZqh
    LtvhPkvCAn2srERv

    • Locate the gold flap and use tweezers to lift the flap up.

    • Use a second pair of tweezers to pull the gold tab connected to the camera out of the circuit board.

    • Once the tab is removed from the circuit board, pull the camera out of the tablet.

    • Caution! Be sure to avoid pulling the gold flap off the the circuit board.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Samantha Rollings

Member since: 30/03/15

349 Reputation

0 comments