Cobra SPX 5300 Display Screen Replacement

Written By: Fanny Auad
  • Comments: 1
Cobra SPX 5300 Display Screen Replacement

Difficulty

Moderate

Steps

8

Time Required

8 minutes

Introduction

If you are having difficulties looking at the display screen of your Cobra SPX 5300 this guide will walk you through its replacement.

  1. XlwqXpZDjPunEatF
    XlwqXpZDjPunEatF
    eQDPk3gdqt2YITML

    • Remove the four 9.5 mm Phillips #0 screws from the back of the device.

  2. YVQZIquXSLEtGFAM
    YVQZIquXSLEtGFAM
    eJnDfLTqM3fTo1xE

    • Pull the black plastic back case off of the device.

  3. eDnd1jveGsFaLqJ1

    • Lift up the motherboard and lay it flat next to the device.

    • Be careful not to sever the wires. The buttonboard is connected to the motherboard by the wires.

  4. DAL6qIMhXESf2eBb

    • Remove the windshield bracket mount.

  5. TFNYoVwPVpPE1fRy

    • Remove the four 4.8 mm Phillips #00 screws from the buttonboard.

  6. V16ehJHEEjV15mhk

    • Lift buttonboard to expose silver button plate.

  7. GyqKbXTXlXIUVamP

    • Remove the silver button plate by gripping one of the corners and pulling up.

  8. Y41JN4hLCoAKX5s3
    Y41JN4hLCoAKX5s3
    KeayEWATxTiyyiZP

    • Lift the front black plastic display screen.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Fanny Auad

Member since: 25/09/15

286 Reputation

One comment

Hi,

Cobra SPX 7800 BT - Radar Detector

Does anyone know where could I purchase or look for a replacement screen for a Cobra SPX 7800 Bt detector, mine came with several cracks on the bottom right hand corner. It works, beeps ok, no color screen display and therefore unable to change settings.

Thanks

Ancient warrior -