Introduction
-
-
Use a Phillips #00 screwdriver to unscrew the four 1.1mm long screws on each corner located at the top of the cover.
-
-
-
Similar to the last step, flip the cover over and use a Phillips #00 screwdriver to unscrew the four 1.1mm long screws on each corner located at the bottom of the cover.
-
Remove the warranty sticker across the bottom.
-
-
-
Gently take the cover apart using your hands separating the top and bottom.
-
The outer shell is expected to easily come apart.
-
-
-
Using the plastic opening tool, wedge the tool underneath the bottom left edge of the hard drive.
-
Raise the bottom edge of the hard drive 15 degrees up from the device.
-
-
-
Place fingers on the IDE connectors gently picking up and sliding the hard drive out from the IDE module.
-
To reassemble your device, follow these instructions in reverse order.
