CHI Spin N Curl Rotating Curler Power Cord Replacement

Written By: Jacqueline Ramirez
  • Comments: 1
CHI Spin N Curl Rotating Curler Power Cord Replacement

Difficulty

Moderate

Steps

5

Time Required

15 - 25 minutes

Introduction

The CHI Spin and Curl Rotating Curler should work efficiently when plugged in. If the device still does not work after changing batteries or checking the power source, the issue may lie within the power cord. This guide will demonstrate how to replace the damaged power cord and fix the device.

WARNING: electricity hazard. The individual repairing should be aware of the danger of working on this project while the electricity is running on the device.

  1. QQAcNGQWaHpFd1Lu

    • Use a metal spudger to pry off the silver, shiny trim.

  2. WXZIAikakUXuCYLf

    • Remove inner black housing of the CHI Spin N Curl using the metal spudger to pop it out.

  3. FmsguqA3EhGWYARm
    FmsguqA3EhGWYARm
    Rn4xAQ3Be5YLybSW

    • Use a 2 mm flathead to remove the two screws.

  4. kRANKNE1oydI6yAE
    kRANKNE1oydI6yAE
    vcPRTjNXG1CQKrly

    • Use a metal spudger to pry open the seams of the device.

  5. QQBEivNkOQAGjYnW
    QQBEivNkOQAGjYnW
    pNw2qTyE6K1QwLGP
    1erXxJjucZYjIgyV

    • Toward the bottom of the device, grab the swivel power cord.

    • Gently pull the power cord to detach it from the CHI Spin N Curl

    • Replace the faulty cord when the original cord has been removed.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Jacqueline Ramirez

Member since: 26/10/22

175 Reputation

One comment

but where to get new cable?

Kristián Feldsam -