Body Cover Removal

Written By: Sam Gustafson
  • Comments: 0
Body Cover Removal

Difficulty

Easy

Steps

8

Time Required

5 minutes

Introduction

How to remove the covers from the body of the camera.

  1. lgs2BFmwctNUvEEY

    • Push down on the screw to depress the spring loaded hinge and release the door.

  2. xqMOa4QfTrEMSjLQ

    • Remove six 5.3 mm #00 screws.

    • Remove one 3.4 mm #00 screw.

    • The short screw has a machine thread and screws into the plate underneath. The rest screw into the plastic body.

  3. JBNm1gvrrVIsOnvC

    • Remove three 5.3 mm #00 screws (the bottom-most screw is not always present).

    • Remove one 7.3 mm #00 screw.

    • Remove the remote trigger cover.

  4. kaurbKcGc3sICMvp
    kaurbKcGc3sICMvp
    qAMWaUYPEdKSqKBQ

    • Remove one 3.4 mm #00 screw.

    • Remove two 5.3 mm #00 screw.

    • Gently lift up on the flash housing to help remove the cover if necessary.

  5. XTT2gETZspMWvdLW

    • Remove two 3.9 mm #00 screws.

  6. 3my2vQuEkTFMiy1K

    • Slide the eye cup up and off to access the screws underneath.

  7. e53TOwaDpAgeyAD6
    e53TOwaDpAgeyAD6
    OJJ5WDhEjPdLrFAa
    XYapgMENQtcSAZZH

    • Remove two 5.3 mm #00 screws by the eyepiece.

    • Remove one 6.8 mm #00 screw in the battery compartment.

    • Remove one 7.0 mm #00 screw near the take up spool.

  8. htpX4AygbXbvTyuw

    • Lift the cover so it is just free of the body. It is still attached by several wires.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Sam Gustafson

Member since: 02/09/22

4686 Reputation

0 comments