Black and Decker LI2000 Orange Casing Replacement

Written By: Katherine Simmons
  • Comments: 1
Black and Decker LI2000 Orange Casing Replacement

Difficulty

Easy

Steps

4

Time Required

5 minutes

Introduction

The orange casing must be removed before accessing the rest of the parts.

  1. FxUQHaFXBBWDEdga
    FxUQHaFXBBWDEdga
    yTkaMN6UyjstKsTN
    oVTmmmgUBASMYQFH

    • Remove the following five screws

    • Three 20 mm Phillips #1 screws

    • One 10 mm #000 Phillips screw

    • One 13 mm Phillips 31 screw

    • When you remove the 13 mm screw, the spring may pop out of the screwdriver. Point the backside of the screwdriver away from your face and others.

  2. QDlNel2OsDxDDcwW

    • Remove the black sticker with recycling information.

  3. tECvLjDYhnRy44Jg

    • Use your fingers or a plastic opening tool to pry the casing apart.

  4. ZWUT2ltVjCSLGayD

    • Remove the plastic slider by picking it up off the screwdriver.

    • You may consider leaving half of the casing on the screwdriver to make handling the screwdriver easier.

    You should also leave the switching slider on the motor as it is DIFFICULT to reinstall the switch assembly.

    Bob -

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Katherine Simmons

Member since: 08/02/16

753 Reputation

0 comments