Background setup - DIY *V1*

Written By: Nick
  • Comments: 0
Background setup - DIY *V1*

Difficulty

Moderate

Steps

2

Time Required

No estimate

Introduction

This guide is a prerequisite for the following guides: [invalid guide link]. It is not intended to be used as a standalone guide as it is used when integrating steps where I need standardized instructions. It will make no sense as a solo guide.

  1. VDhWUmohhYKPQcQl
    VDhWUmohhYKPQcQl
    4AnYG5HB2ps6Juok
    o62DlsOCwSGMIvnh

    • THIS STEP SHOWS TWO EXAMPLE SETUPS. As long as there is no nonwhite background visible (or it is correctable in post), build this how you see fit.

    • When using posterboard, use the MATTE side. Glossy materials and light do not mix, and reflect light in ways not found with matte materials.

    • Setup a backdrop support. This can be anything from a trifold board cut in half (the style you used in "school") or a custom design. I chose a custom design to conform it to my design spec and make the modifications I wanted.

    • Setup your white background. Once the backdrop is stable, minimize as many unsightly areas as possible. You are ready.

    • Take a few test photos (Optional). If you are unsure about the end result, take 1-2 test shots for review. Make adjustments until you are happy with the end result.

  2. 5CFKWZhVAEm1BXAn
    5CFKWZhVAEm1BXAn
    WCSrQZtYHDHc1XNw
    SE2vkpZMQcZYEruv

    • I have already assembled this one, but assembly is simple.

    • Place a few support brackets on the lower piece. Add screws as your brackets permit.

    • Hold the top piece up and add screws to the top side.

    • Once assembled, you are ready to use the backdrop.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Nick

Member since: 11/11/09

90422 Reputation

0 comments