Introduction

If for any reason you need to replace the front side M.2 SSD on a Asus ROG Strix X570-I Mini ITX motherboard, the replacement process can be found in this guide. In order to not damage or stress the motherboard, following a proper process is necessary in replacing this M.2 SSD. Be sure to keep your computer on a table away from any carpet or non-hardwood flooring. Keeping a static free environment is necessary to reduce the risk of shocking the circuits within your components. Remember to disconnect all USB devices and the power cable for the computer to avoid bodily harm.
Step 3 requires you to remove the graphics card; be especially careful about this step as graphics cards tend to be the the most expensive part in your PC.

  1. sRF2WHRYcZmGxy2A
    sRF2WHRYcZmGxy2A
    VlYXdf3VOUmDIBKx
    • Remove the front panel.

    • This may involve one or two thumb screws depending on your case.

    "This may involve one or two hand screws depending on your case"
    -----------------------------------------------------------------------------

    I believe mine had/has - ish; had re-ordered some lost now I use a strong magnet changed my life.

    Two, though, was a good day, one; meager.

    Sometimes I'd just have lay it on its side and lay the side removal wall on top at 45 degrees evolving it into a lid.

    --------------------------------------------------------------------------------------------------------

    Did you mean 2x - screws screwable by hand or - screws you need two hands to screw and unscrew ?

    Christopher Leslie-John Peters -

  2. nrbIaI1OoBfdqVMu
    • Detach the PSU cable from your graphics card.

  3. ThD5saMmjdVOpABM
    ThD5saMmjdVOpABM
    Py1wtKygBqICmYVl
    agb2MKOTtYpeUnWq
    • Unscrew the back panel screws to release the graphics card.

    • Release the PCIe switch.

    • Be careful when using a tool as you can damage the motherboard if the tool slips.

    • Take the graphics card out vertically.

  4. mWtvArguyRbZCMSi
    mWtvArguyRbZCMSi
    OTLOUaeOoLsEECXb
    gKqOWVTuniLdpS6r
    • Unscrew the heat-sink screws.

    • Remove the heat-sink vertically.

    • It is important to remove it vertically as there are pins on the right side that must not be bent.

  5. voGLYYeXQeJPBWDv
    voGLYYeXQeJPBWDv
    xWySRgsvHEOCWCgW
    HH6DhRPx2cZTBWi1
    • Unscrew the small screw holding the SSD.

    • Remove the SSD at an angle.

    • Be careful to avoid grabbing the SSD from its circuit.

    • Insert a new SSD at a 30-40 degree angle.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Christian Clark

Member since: 22/02/22

205 Reputation