Altec Lansing OVO Bluetooth Speaker Disassembly

Written By: Nuno
  • Comments: 1
Altec Lansing OVO Bluetooth Speaker Disassembly

Difficulty

Easy

Steps

5

Time Required

2 - 5 minutes

Introduction

This guide is a dissasembly of the Altec Lansing OVO Bluetooth Speaker.

  1. RrdMfKjBvl6jJMpx

    • This is the unit that we are going to disassemble.

  2. aFH6rYJhUQDXMHNs

    • Screws approximate location behind the front cover.

  3. GZMPSQulbnRvCIp5

    • Use a pick to gently pull the cover. There are no fragile parts. The cover is made of metal and covered with a type of mesh.

  4. goNSmNbBgUeFu3sX
    goNSmNbBgUeFu3sX
    Q2OjJc2JLGwMx6KH
    ocRaBTBVyArSgDJw

    • Once the front cover is removed gently lift the thin protection layer in order to find the holes where the screws are located. In order to find the two middle screws you will have to make two small incisions as shown in the picture.

  5. GeM4l2JkwPUlccuv
    GeM4l2JkwPUlccuv
    QhrBmMqkwvinoyTp

    • After you remove the 13 screws, put your finger in the woofer hole on the back of the speaker. Pull gently outwards to make sure you don't break the flat cable that connects the back to the main board. And that's it! Now you have full access to all the inner parts of your speaker.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Nuno

Member since: 02/03/22

181 Reputation

One comment

What is the spec on the battery in this unit (Altec Lansing OVO AL-BT42S)?

Hugo -