Adding a Power Fuse to U2C on Troodon with Can Bus

Written By: AJ Pereira
  • Comments: 0
Adding a Power Fuse to U2C on Troodon with Can Bus

Difficulty

Moderate

Steps

3

Time Required

No estimate

Introduction

  1. HP5msfXsyFuYtvhW
    HP5msfXsyFuYtvhW
    SuGBwmeOBOuud1xU
    PVyuUtWSHFUlNdQD

    • Shut down printer and unplug the power cable from the printer

    • Loosen the front panel screws, then remove the front cover panel and set the cover down in front of the machine.

    • Note, you will need about 6-8 inches of space in front of the machine to set the front cover panel down on, so you can work on the machine

    • Locate the power cable coming from the power supply.

    • Pull it forward slowly

    • Give your self about 6-8 inches of cable from the U2C power terminal and cut the power cable

  2. MM1oVsHsdnEcPPqm
    MM1oVsHsdnEcPPqm
    AMFxdbRKpWBF1usI
    MvRfPqo6vtDHhbB6

    • Once the cable is cut, strip both ends of the wire back 8-10 mm.

  3. AbpwDEgNR34PIrln
    AbpwDEgNR34PIrln
    mRHSasiqZVBMMraG
    JH2cypk363MPGFb1

    • The wire is going connect to go into the Wago connector then through the fuse and back to the U2C

    • The fuse holder/ Wago is non - directional, so it does not matter which side is in out. Either way will pass the power wire through the fuse correctly.

    • Lift up the orange lever on an open terminal and insert one stripped end as far into the hole as possible then snap the lever closed. Repeat for the other side.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

AJ Pereira

Member since: 29/05/20

2689 Reputation

0 comments