Introduction

The EMI shield protects the power supply and circuit board from electromagnetic radiation.

  1. HRgsb1weOtgNOubO
    • Lay the monitor on a flat surface so that the back is facing up.

  2. yLALqinZuXqIFRiO
    yLALqinZuXqIFRiO
    CWRFoOvhtCDghDAE
    • Grab the hinge cover with both hands on either side of the stand.

    • Squeeze inwards with your thumbs and fingers and lift up to remove the hinge cover.

  3. O6MxEGAXNko6ChSK
    O6MxEGAXNko6ChSK
    eab1c2ZIFMTUZLYB
    • Remove the four 12.1 mm Phillips #2 screws that hold the stand to the monitor.

    • Support the monitor while removing the screws to prevent the monitor from falling.

    • Lift up to detach the stand.

    I can't get a grip to squeeze and lift the hinge cover. My fingers just slide right off.

    az_irocdriver -

  4. uOSWFXcNLQZsMIQA
    uOSWFXcNLQZsMIQA
    KBUEUrPVHVsaGqJl
    • Remove the five 9.5 mm Phillips #2 screws located around the perimeter of the monitor.

  5. BjcmcegYghgMqJv2
    BjcmcegYghgMqJv2
    pfSnUCBQqEcWhfJi
    OWxBN5G4IlAoEKkr
    • Starting at the corner of the monitor, wedge the small plastic opening tool between the back cover and the display bezel.

    • Tilt the plastic opening tool up to separate the back cover from the display bezel.

    • Continue around the perimeter of the monitor until the display bezel comes off.

    • A reasonable amount of force is necessary to detach the back cover from the display bezel.

  6. QOwLqUg15wbSjKlH
    QOwLqUg15wbSjKlH
    4BSMwGQtRfKDx5Q2
    • Reposition the monitor so that the back is facing up.

    • Grab the corners of the monitor and jiggle them upwards to detach the back cover from the inside of the monitor.

    • Lift the back cover up.

  7. ktigIxK1tj4tBwcA
    ktigIxK1tj4tBwcA
    wxMt3antMANIGVEA
    • Remove the two 5.7 mm Phillips #2 screws located on either side of the EMI shield.

  8. 1G4QRwRZJUIFpxY5
    1G4QRwRZJUIFpxY5
    AbiZAgqSELHsaLXe
    • Using a nut driver (or if necessary, needle-nose pliers), remove the two nuts on either side of the VGA input.

  9. TAk3GfEJK6JYyprY
    TAk3GfEJK6JYyprY
    HPUZixgK2UJMjMWp
    Zqja3AEVgeRSHMtC
    • Grab the metal casing by the sides and slide it down towards the bottom of the monitor.

    • Lift up to remove the metal casing.

    • Beware, metal casing is sharp!

Conclusion

To reassemble your device, follow these instructions in reverse order.

Taylor Atterbury

Member since: 06/10/11

717 Reputation

0 comments