Introduction

This guide will require you to disassemble the rear and side panels of the printer in order to access the circuit board.

  1. AMciVB3XetABhW11
    AMciVB3XetABhW11
    JwE2ZLpVsyvDQ6Mp
    IJVwQZDGsLqb3xok
    • Remove the top hinged panel by taking out the pins at the bottom of this panel.

  2. JmUfmbvf11lfOByC
    • Using a Phillips #2 screwdriver, remove the four screws on the back of the printer.

  3. NLXCK3NIUMh1nDrI
    NLXCK3NIUMh1nDrI
    soh2vPweOh6p4xk1
    ZU1asE44wP5uGAH4
    • Gently lift the top panel while simultaneously pulling off the back panel.

    • Before pulling out the back panel entirely, make sure to remove the rear cooling fan from its slot.

  4. em1VUGEHRn2QmBem
    em1VUGEHRn2QmBem
    UFOGkag3ZgOTwjLK
    eBlSn4YS6Rf2UFsN
    • Remove the front panel by gently freeing the holes on the panel from the pegs attached to the main printer body one at a time. Make sure to remove the entire front panel, not just the flap on the paper tray.

  5. UYvOq61BB4yXgoEb
    • Using a Phillips #2 screwdriver, remove the two 1" screws on the front face of the printer.

  6. TFwYFUeqo5NvN2KK
    TFwYFUeqo5NvN2KK
    igN1c6JqngduIDsK
    bdxvDvCEXmpZMPP3
    • Using a plastic opening tool, gently lift one side of the top panel from its peg.

    • Repeat the process for the other side.

    • Lift the top panel from the front to remove it entirely.

  7. HaMFHkpcnI6121sp
    HaMFHkpcnI6121sp
    LQEkUkNv2H2L5s2V
    GJ3ZHPSKMAqdcISu
    • Lift the right panel up from the raised stops.

    • Rotate the panel gently as indicated in the picture to remove the panel entirely.

  8. i4jFFw6AFUXYjI2x
    • Using a Phillips #2 screwdriver, remove the four 1" screws attaching the gray plate to the printer.

    • Remove the plastic cover by sliding it carefully under the silver hinges on the right.

  9. 1yVHZPemBh3hAclb
    • Using a Phillips #2 screwdriver, remove the 1" screw attaching the circuit board to the printer.

  10. yVTkCLTstnT1VmON
    yVTkCLTstnT1VmON
    5MkqkdXRQWlaSbGF
    • Turn over the circuit board to access main wiring.

    • Unplug the wiring from the circuit board gently.

Conclusion

To reassemble your device, follow these instructions in reverse order.

bbaustin

Member since: 12/10/11

268 Reputation

0 comments