Introduction

Looking to replace your damaged temperature controller and don't know how? In this installation guide, we will teach you how to replace a new temperature controller. You can easily do it in just a few steps. This installation is based on the AUX-208P1 electric kettle, but the same concept is also applicable to the replacement of other electric kettle temperature controllers.

  1. OYUIZGXUleXQUktC
    OYUIZGXUleXQUktC
    6wGsHUcnNtQN5SJP
    • Clean all the dirt on the bottom of the electric kettle.

  2. UV6eTEt5JX5vTFiP
    UV6eTEt5JX5vTFiP
    dBGYYipTCVxxxUhq
    • Use a Phillips #0 screwdriver to remove the three 19 mm screws at the bottom of the electric kettle.

    • Remove the base of the electric kettle.

    • Remove the LED indicator buckled on the base.

  3. vqNFQxAkIAKMrRjh
    vqNFQxAkIAKMrRjh
    qGucdvCwTVEoHKGS
    • Use combination pliers to clamp the connection between the electric kettle line and the old temperature controller to create a gap, and pull it off.

    • Don't use too much force to avoid damage to the line!

  4. ZfZVCOoHLIBGGyaG
    • Use combination pliers to remove the nuts holding down the old temperature controller.

  5. EHnuTbCwLXmDfvJO
    EHnuTbCwLXmDfvJO
    d1GmjngkKd43lGZa
    • Remove the broken temperature controller.

    • Clean the bottom of the kettle to remove any dust or debris buildup.

  6. x6UTMEOr3w3vWqaX
    • Align the socket on the bottom of the new temperature controller with the protrusion on the bottom of the electric kettle to assemble.

  7. iALwrivyLWKrGHAO
    • Use combination pliers to reinstall the nuts holding down the temperature controller.

  8. R42OIriBIikkFFPW
    • Fasten the electric kettle circuit to the contact reed of the new temperature controller.

    • Gently pull the interface to ensure a firm installation.

  9. alLveOap6bkng1oD
    alLveOap6bkng1oD
    Ebb1Y1JR4KwOSS5X
    • Re-buckle the removed LED indicator back to the base.

    • Buckle the base back to the bottom of the electric kettle.

    • Use a Phillips #0 screwdriver to three 19 mm screws on the bottom of the kettle.

Conclusion

重新组装设备时,请依次相反的拆卸顺序。

SHAN HUANG

Member since: 14/01/21

193 Reputation

0 comments