Introduction

Batteries in laptops tend to die out early, especially the lower-end laptops. Doing this replacement will allow your computer to have more longevity. This guide aims to replace the battery for an ASUS R554L laptop. Make sure that you are working in a well-lit open area. After the battery swap, make sure to test to ensure it's working correctly. To do this, leave the charger in overnight to ensure that the battery is holding a charge.

  1. LQRgIuJP1jGXj6I1
    • Flip the laptop so the bottom is facing upward.

    • Remove ten screws using a Phillips #0 screwdriver.

  2. vFxQAGbSpHTF6QwU
    vFxQAGbSpHTF6QwU
    HUJvLkGUSDNBprDj
    5wvyAPStTtGgxx4p
    • Using your fingertips, carefully pull the backplate in an upright direction.

    • Continue along the edges until the backplate is fully removed.

    • It's normal to hear cracking while pulling up on the plate.

  3. 63kdfJZZsK1toKG6
    63kdfJZZsK1toKG6
    ViTGRwyQRHoRDeei
    fWK4PgBWTDLAwSjw
    • Remove the four screws from the battery using a Phillips #0 screwdriver.

    • Pull up on the cable connected to the motherboard to remove.

    • Remove the battery from the bay.

  4. I1JZYCnSGkicaiyp
    I1JZYCnSGkicaiyp
    XWwXPORFFSuGMxxV
    VXF3RCBHLlWoMYEU
    • Place the new battery in the bay.

    • Install the battery cable to the motherboard, applying pressure in a downward direction.

    • Screws the screws back in using a Phillips #0 screwdriver.

  5. vVAGdx6FQbABGcrp
    vVAGdx6FQbABGcrp
    bOHUcx3nSv6DLdOn
    MdisKtEZDACKJ2DH
    • Align the backplate.

    • Starting with the upper right corner, apply pressure in a downward angle.

    • Repeat the process around the backplate until it's fully secure.

  6. Icb1JL2KOSDFW3Fn
    Icb1JL2KOSDFW3Fn
    Y3DJDq6GeADvFOxF
    • Screw the backplate screws back in using a Phillips #0 screwdriver.

Conclusion

Once the new battery is installed, leave the charger connected to the laptop over night to ensure the battery is holding a charge

Joshua Chavez

Member since: 01/02/22

160 Reputation

0 comments